ACL2025 Portable Car Lift 4400 lbs with 5500 lbs Scissor Jack, 3-Stage Telescopic Garage Lift

ACL2025 Car Lift is a versatile vehicle lifting solution for home garages, DIY mechanics, and light-duty workshops. This combo features a 4,400 lbs portable tilting car lift with a 3-stage telescopic frame and a 5,500 lbs scissor jack for added safety.

Fast Setup. No Waiting

The ACL2025 goes from flat to upright in as little as 40 seconds, saving valuable time and getting you to work faster.

Key Features

1. 3-Stage Telescopic Frame – Compact Storage, Extended Reach

• Storage Length: 30.5 inches – fits in most car trunks or garage corners
• Extended Length: 60.2 inches – reaches chassis lift points on sedans, SUVs, and light trucks
• Collapsible design eliminates the need for a dedicated storage space

2. Dual Load Capacity – Lift with Confidence

Safety Note:Always use the included scissor jack as a secondary support. Never work under a vehicle supported only by a hydraulic lift.

3. Low-Profile Design for Easy Access

• Minimum Height: 5.9 inches – slides under most sedans and SUVs
• Maximum Height: 23.0 inches – provides ample clearance for wheel and brake work

4. Heavy-Duty Steel Construction

• Built with high-strength steel frame for durability and stability
• Corrosion-resistant finish for long service life
• Non-slip rubber lifting pads prevent vehicle slippage during operation

5. Complete Safety System

• Hydraulic velocity fuse valves prevent sudden descent in case of hose failure
• Mechanical safety lock on scissor jack engages automatically
• Overload protection – designed with 20% safety margin below rated capacity

How It Works – Drill-Powered, Effortless

No hand pumping. No air compressor. No electricity needed.

The ACL2025 uses a standard drill to power the hydraulic pump. Just attach, pull the trigger, and the vehicle rises smoothly and quickly with zero effort.

Two steps:

1. Slide the telescopic frame under your vehicle
2. Pull the drill trigger – the lift does the rest

No sore arms. No complex setup. Just clean, drill-powered lifting.

Technical Specifications

The rear of the vehicle can be lifted up to 105 cm, while the front can reach 80 cm, allowing the car to be fully elevated off the ground. The center section has a ground clearance of 58 cm.

Who Is This Combo For?

No Wiring Needed

Say goodbye to cords. The ACL2025 only requires a power drill (not included) to lift and lower a vehicle. A 13 mm chuck drill with at least 70 N·m torque is all you need to get the job done. There’s no need for an air compressor or messy air lines.

The ACL2025 is a portable, fully mechanical vehicle lift with no pneumatic or hydraulic components.

What’s Included

• 1 × AIOLITH ACL2025 Main Lift Unit 
• 1 × AIOLITH ACL2025 Scissor Jack 
  
• 5 x Drill adapter
• 1 x Hand-operated crank
• 2 x Safety pin
• 1 × User Manual with Safety Instructions
  

Safety & Quality Assurance

• ISO 9001 Certified Manufacturer
• Tested at 120% of rated capacity for structural integrity
• Hydraulic system equipped with velocity fuse – automatically locks if hose bursts
• ANSI/ASME PASE 2019 Safety Standards compliant
• 1-Year Limited Warranty against manufacturing defects

Important:Always read the user manual before operation. Never exceed rated capacity. Always use the included scissor jack as secondary support.

Pro Tips for First-Time Users

1. Always use on a flat, level surface
2. Position the lift at manufacturer-recommended chassis points
3. Place the scissor jack before working under the vehicle
4. Store in a dry indoor location
5. Inspect hydraulic hoses and fittings before each use