Rotary Floor Brush Guide: 10 Factors to Evaluate

Rotary Floor Brushes: What to Verify Before Use

A rotary floor brush provides mechanical agitation when attached to a compatible floor scrubber. Cleaning performance depends on the machine, brush material and condition, floor, soil, chemical, pressure, solution flow and travel speed.

The current Aiolith accessory linked in this article is the 21-inch polypropylene rotary scrub brush for AF2217 and AF2225.

---

1. Current Aiolith Brush Specifications

Item	Current Product Information
Brush Diameter	21 inches
Material	Polypropylene bristles
Compatible Models	AF2217 and AF2225
Included	1 × 21-inch rotary scrub brush

---

2. Current Floor Applications

The current brush product page lists routine and deeper scrubbing of suitable hard floors including:

• Tile
• Concrete
• Terrazzo
• Epoxy
• Other water-safe commercial flooring

This does not establish compatibility with hardwood, carpet, natural stone or every specialty finish. Follow the floor manufacturer’s requirements and test the complete setup before broad use.

---

3. Brush Material Is Only One Part of Cleaning Performance

Polypropylene bristles provide mechanical agitation, but they do not guarantee removal of grease, stains, biological contamination or embedded soil. Results depend on the floor, contaminant, chemistry, dwell time, brush condition, machine settings and operating method.

---

4. Do Not Assume Fixed Time Savings

A rotary brush may reduce repetitive manual scrubbing on suitable routes, but there is no universal 30–50% time saving or fixed minutes saved per job. Measure the actual route under comparable conditions.

---

5. Do Not Assume Fixed Water or Chemical Savings

The brush itself does not establish an 80% water reduction or a universal chemical saving. Water and chemical use depend on the machine, solution-flow setting, dilution, floor, soil, cleaning frequency and operator procedure.

---

6. Cleaning Is Not Disinfection

A rotary brush can agitate soil, but it does not by itself disinfect a hospital, school or other facility. If disinfection is required, use an approved chemical according to its label, including concentration, coverage and contact time, and follow the facility’s procedure.

Only use chemicals that are compatible with the machine, floor, brush and recovery system.

---

7. Surface Preservation Depends on Compatibility

A rotary brush can help remove abrasive soil from a compatible floor, but it does not guarantee longer floor life or fewer repairs. An overly aggressive brush, chemical or operating setup can damage a finish.

Match the brush and process to the flooring manufacturer’s maintenance guidance.

---

8. Installation and Replacement

Turn off the machine and disconnect it from its power source before replacing the brush. Transfer the compatible mounting adapter from the original brush if required, secure the replacement brush, and confirm it is locked in place before operation.

The current product page does not specify a fixed 6–12 month replacement interval. Replace the brush when the bristles are shortened, uneven, permanently bent, missing, or no longer provide consistent agitation and floor contact.

---

9. Maintenance

• Remove debris from the brush after use.
• Inspect bristles for uneven wear, deformation or missing sections.
• Inspect the mounting connection before operation.
• Use compatible cleaning solution and follow machine instructions.
• Replace based on actual wear and performance.

---

10. Match the Brush to the Exact Machine

Do not select a replacement brush only by nominal machine working width. The current Aiolith 21-inch brush is specifically confirmed for AF2217 and AF2225. It is not confirmed by this product page for AF2013 or non-Aiolith machines.

---

FAQs

Can I use this brush on hardwood?

The current product page does not list hardwood. Do not assume compatibility; follow the flooring manufacturer’s requirements and use a confirmed floor-care setup.

Can I use it on carpet?

The current product page lists water-safe commercial hard floors, not carpet. Use equipment and attachments designed for the carpet-cleaning process.

How often should I replace the brush?

There is no fixed calendar interval. Replace it based on bristle wear, deformation, missing bristles and declining floor contact or agitation.

Can disinfectant be used with the brush?

Only if the chemical is permitted by the machine and floor instructions and its label allows the intended process. Brush agitation alone does not prove disinfection.

Which Aiolith models use the current 21-inch brush?

The current accessory page confirms AF2217 and AF2225.

---

Conclusion

The current Aiolith rotary scrub brush is a 21-inch polypropylene accessory confirmed for AF2217 and AF2225. Choose it by verified machine compatibility and supported floor applications, and replace it according to actual wear rather than fixed performance, savings or lifespan claims.